With the increasing input power, the electrons injected into the Si NC layer are more
energetic due to higher electric field. As a result, the hot electrons could pass through the SiN x without recombining at the Si NCs, resulting in the decrease in output power, i.e., WPE. This phenomenon would be depressed if the defects in the SiN x will be decreased through the growth optimization selleck chemicals of the surrounding SiN x matrix. An alternative possibility for enhancing the recombination efficiency of electron–hole pairs at the Si NCs could be the design of the luminescent layer containing the Si NCs such as the multi-quantum well structure or electron blocking layer for preventing electron overflow from the luminescent layer generally used in organic, GaN-, and GaAs-based LEDs [21–24]. Based on the results of light output power and WPE, as can be seen in Figure 3c,d, use of the SL structure is a crucial role in enhancing the light output power and WPE of the Si NC LED. Figure 3 PL,EL,light output
powers,and WPEs. (a) PL spectrum taken from the Si NCs in the SiN x . The main peak position was around 680 nm. (b) EL spectra taken from the Si NC LED with 5.5 periods of SiCN/SiC SLs. The main peak position was around 680 nm. (c) Light output powers of Si NC LEDs with and without 5.5 periods of SiCN/SiC SLs, respectively. (d) WPEs of Si NC LEDs with and without 5.5 periods of buy Pevonedistat SiCN/SiC SLs, respectively. Figure 4 shows a schematic bandgap diagram of the Si NC LED Y-27632 2HCl with 5.5 periods of SiCN/SiC SLs. A dashed oval in the upper part of Figure 4 shows a conduction band diagram at the interface between SiCN and SiC layers in the SLs showing the formation of 2-DEG. It is generally known that the SLs are widely
used to enhance the carrier transport to the active layer [25, 26]. By assuming the band offset (ΔE) to be half the difference in the bandgaps of the SiCN (2.6 eV) and SiC (2.2 eV) layers, the conduction band offset (ΔE c) is 200 meV since the total band offset is 400 meV. Because of this ΔE c, the 2-DEG, i.e., uniform electron sheet, can be formed along the lateral direction of the SiC layer to Captisol cost coincide the Fermi level of the SiCN and SiC layers. Another important thing is the lowering of the tunneling barrier height for electrons to transport into the Si NCs. For the SiCN layer, the electrons have a lower tunneling barrier by 200 meV due to the higher bandgap, as can be seen Figure 4. These indicates that the electrons can be efficiently transported into Si NCs through the overlaying SiCN layer compared to the SiC layer, resulting in an increase in the light emission efficiency.