Participants started with a ramp cycle

Participants started with a ramp cycle ergometer test to determine P peak and V̇ O2peak. After a 3-min rest, the ramp test started at 100 W and involved power increases of 9 W every 18 s (30 W∙ min-1) until volitional exhaustion. For all tests, participants were asked to maintain a selleck screening library cadence of 80 revolutions per min throughout the test. Volitional exhaustion, i.e. task failure, for all cycling tests was defined as the point in time when participants stopped pedaling or the cadence fell below 75 revolutions per selleck products minute for > 5 s. On each of the following testing days, one constant-load trial at different power output was completed to determine CP. After a 3-min

rest, participants started with a 5-min warm-up at 75 W [25]. The power was then increased immediately to 85%, 90%, 95% or 105% of P peak in a randomized order (modified from Brickley et al.[25] including the 85% stage). These endurance capacity tests were conducted MGCD0103 until task failure. Using the T lim from these tests, CP was then calculated from the linear power-time-1 equation [24]. Constant-load cycling trials at ‘critical power’ During each of the two intervention periods, five constant-load trials at CP were

completed on five consecutive days. These trials started with a 3-min rest and were followed by a 5-min warm-up at 75 W. Subsequently, power was immediately increased to the previously calculated CP and participants were encouraged to maintain the given cadence for as long as possible. Gas exchange and heart rate analysis Participants were equipped with a facemask, which covered their mouth and nose (Hans Rudolph, Shawnee, Molecular motor KS, USA). The facemask was connected with an anti-bacterial filter (PALL PRO1087, Pall, East Hills, NY, USA) to an Innocor™ device (Innocor™, Innovision, Odense, Denmark). Pulmonary gas exchange

and ventilation were continuously measured breath by breath throughout all ergometer trials. Throughout all cycling tests, heart rate was recorded (Polar S610i, Polar Electro, Kempele, Finland). V̇ O2peak, V̇ O2 during the constant-load trials at CP (V̇ O2,CLT), carbon dioxide output during the constant-load trials at CP (V̇ CO2,CLT), respiratory exchange ratio during the constant-load trials at CP (RERCLT) and heart rate during the constant-load trials at CP (HRCLT) were determined as the highest mean over a 10-s period. The V̇ O2 slow component was calculated as the difference between the changes in V̇ O2 between min 2 and task failure and between min 2 and 6. Blood analysis For the analysis of [HCO3 -], [Na+], pH and actual base excess (ABE) 125 μl blood from the same earlobe were always obtained 75 min after the NaHCO3 ingestions and 15 min before the constant-load trials at CP on 1 and day 5. Blood was collected in a heparinized glass capillary tube and analyzed using a clinical blood gas analyzer (ABL 505, Radiometer, Copenhagen, Denmark).

Comments are closed.