7Å (MSE = 0.013), that is, a total polypeptide/enzyme thickness of 105 ± 3.7Å. Figure 2 The dry nanofilm thickness of 40 ± 3.4Å nm increased considerably when bovine trypsin adsorbed to the film surface, whereas it remained less affected when exposed to the V8 enzyme, at ambient temperature. The bacterial protease V8 behaved differently. The thickness of the nanofilm did not change much on exposure to the solution of V8 enzyme, as can also be Inhibitors,research,lifescience,medical seen from Figure 2. A four-layer model was used for the V8 enzyme’s adsorption to the film, since

the layer on top of the polypeptide film was very thin. The best fit received a polypeptide/enzyme thickness of 42 ± 2.9Å. The immediate interpretation of this result is that the V8 enzyme did not interact with the polypeptide film, as both enzyme and the polypeptide surfaces were negatively charged. www.selleckchem.com/products/azd6738.html However, Craig et al. showed that this enzyme catalyzed degradation

of the LbL film provided that it was terminated by the anionic PLGA. The reason for this is that the V8 peptidase is known to be reactive in catalyzing Inhibitors,research,lifescience,medical cleavage of Glu-X bonds, Inhibitors,research,lifescience,medical that is, peptide bonds involving a glutamate residue [24, 25]. The LbL film studied in this work had PLGA as the terminating layer. However, the temperatures differed. Whereas the QCM-D measurements were performed at 32°C, which was intended to mimic the temperature of a typical wound, the ellipsometry experiments were performed at ambient temperature. Thus, the temperature is vital and no or little enzymatic degradation occurred at room temperature. This is a practically important piece of information because it indicates Inhibitors,research,lifescience,medical that the wound dressing with the antimicrobial agents covered by the polypeptide lid remains intact until it is contacted by the exudate from a chronic wound at the approximate skin temperature of 32°C. However, the V8 protease may not be entirely inactive also at ambient temperature. The surface Inhibitors,research,lifescience,medical that has been exposed to the V8 peptidase solution seems to be slightly rougher immediately after the treatment (±6Å) than after

one or two days, when all measuring points ended up at the same value (±1Å). This induced roughness of the surface may indicate enzymatic cleavage of the top layer of the film, that is, predominantly of PLGA. 4. Conclusion The (PLL/PLGA)3 nanofilm was measured with ellipsometry to study the thickness in its dry state. When ADAMTS5 comparing with the film’s wet and dry thicknesses, it is clear that about 60% of the wet film consists of water. This result is in accordance with previously reported values from similar systems despite the fact that in the present investigation the polypeptides were adsorbed directly to a tailored gold surface imitating nonwoven and not to a surface treated with a primer such as PEI, which is the normal procedure. This indicates that the character of the film without primer is similar to that with primer.